- Cut track to desired length to fit the location for the Roll Control brackets and
other accessories in boat or van.
- Remove all burrs from exposed ends with a file and radius front edges (Fig. A)
- Drill and countersink holes for 1/4" flat head bolt 1-1/4" from the end
of the track (Fig. B). Screw heads must be flush or below surface of track.
may be mounted flush to surface (Fig. C) or spaced with Roll Control Mounting
Kit to match horizontal or vertical angle of surface (Figs. D & E).
Be sure to allow adequate
room at end of track to allow Roll Control brackets, rod holders and other accessories
to slide in.